Buy EMAX RS2205 2300KV CW/CCW Brushless Motor +RC plane 4 Pcs Fvt Little Bee 20a Mini Esc 2-4s for FPV Mini Racing Quadcopter only US $70.95.
EMAX RS2205 2300KV CW/CCW Brushless Motor +RC plane 4 Pcs Fvt Little Bee 20a Mini Esc 2-4s for FPV Mini Racing Quadcopter
|Use||:||Vehicles & Remote Control Toys|
|Remote Control Peripherals/Devices||:||Remote Controller|
|Technical parameters||:||Value 2|
|Model Number||:||20A and 2300KV|
|For Vehicle Type||:||Airplanes|
|RC Parts & Accs||:||Speed Controllers|
|Four-wheel Drive Attributes||:||Assemblage|
|Tool Supplies||:||Assembled class|
4 pcs EMAX RS2205 2300KV CW/CCW Motor +RC plane 4 Pcs Fvt Little Bee 20a
Mini Esc 2-4s for FPV Mini Racing Quadcopter
RS2205 KV2300 motors from Emax are specially designed for racing quadcopters. They are some of the best racing motors that we have ever seen. The motors use high strength N52 Neodyum magnets, and have active cooling fins that greatly reduce motor temperatures. Besides, the very light weight designs and high quality Japanese bearings make them the best possible performance.
The motor bell and shaft is held down by an enhanced U ring for safety and stability to ensure it doesnt come off. It has dual lock CW and CCW lock nuts. Geared for 3S to 4S use, these motors run M5 shafts, spin at 2300KV, and has a maximum thrust of 1024grams! Using 5x45 inch props will be best on this application, and each motor weighs about 30g.
- Race Spec Performances
- High Strength N52 Neodyum Magnets
- Active Cooling Fins Greatly Reduce Motor Temeratures
- Low CG, Light Weight Design
- Japanese Bearing For Performances
- Enchance Anti Off U Ring For Safety & Stablility
- Dual Lock CW / CCW Locknuts.
- No. of Cells 3 - 4S
- Shaft: M5
- KV: 2300
- Max Thrust: 1024g
- Propeller Suggested: HQ 5045 BN
- Weight: 30g
These are now the esc of choice for all the top FPV Racing Pilots due to there super performance and do not burn out like DYS Escs are known for.
These are flashed with BLHeli and OneShot enabled and with damped mode the throttle response and changes are incredible.
Using Silabs processor and a super fast dedicated chip make these able to freewheel and brake with ease.
Sometimes size isnt everything and its certainly the case with the LittleBee Esc, Weighing in at a mere 4g and only 24.5mm x 12.5mm makes these so small they will fit in virtually any frame.
Factory flashed with BLHeli this firmware unleashes the full performance of these escs.
Oneshot enabled this is a feature that again is used by all the top FPV Drone racers throughout the world.
Easily Upgradeable with a programmer which is available seperate allows all the features and settings to be tweaked to your liking such as enable oneshot, Reverse motor and Dampning. A programmer is recommended for the more serious racer however the default settings out the box are good to go.
Specs and Features of the Little Bee 20a Esc
Oneshot125 is a different and faster communication protocol between the flight controller and the ESC on your quadcopter. It allows the FC to send control commands to the motor quicker, therefore in theory your multirotor should perform better.
This feature allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.
With the BLHELI software rapidly evolving, you can flash the lastest firmware using the 3pin connector and suitable USB adapter and now can be used via the cleanflight GUI please note you will need to be running the Betaflight firmware to connect via the cleanflight interface but this is a simple way of adjusting and tweaking the settings of your escs.
Input: 2-4s Lipo
Constant: 20 Amps
Burst: 30 Amps
Weight: 4g bare board
Motor wire: 70mm
Signal wire: 120mm
PCB - 4 Layer Blind Pole PCB - 3oz Pour
OneShot and BLHeli 14 Pre Installed
Includes 4 Lil Bee ESCs
2pcs CW RS2205 motor
2pcs CCW RS2205 motor
4 pcs Little Bee 20a ESC